PRL Motorsports Titanium Turbocharger Inlet Pipe Upgrade Kit for 2016-2021 Honda Civic 1.5T

Utilize the Titanium Turbocharger Inlet Pipe Kit for the L15B7 from PRL Motorsports to its fullest potential for your 10th Gen Civic's engine intake system and turbocharger. The turbocharger can perform more effectively thanks to this kit, a direct bolt-on improvement that removes the limitation on intake airflow before the turbocharger. Titanium with a thin wall helps prevent heat soak. Our design makes use of a cast aluminum inlet piece to enable a smooth transition from a titanium crossover pipe's gasket-matched 50mm ID compressor intake to a 76.2mm OD/74mm ID output. The factory-installed 38mm compressor outlet diameter has been extended to 45mm. By offering a large increase in airflow volume compared to the original inlet pipe while retaining velocity, we perfectly matched this kit to Honda's 1.5L displacement. Compared to a one-piece construction, a multi-piece design enables simpler installation and better fitment.

NOTES

• NO ECU CALIBRATION REQUIRED
• ONLY COMPATIBLE WITH PRL MOTORSPORTS COBRA CAI SYSTEM OR SHORT RAM INTAKE SYSTEM
  

APPLICATIONS

• Honda Civic 1.5T (2016, 2017, 2018, 2019, 2020, 2021)

FEATURES

• Fits all variant models including Si, 6MT, CVT, RHD, International Models, Etc.
• Fits Factory & Factory Location Replacement Turbocharger Upgrades
• Only pairs with our Cobra Cold Air Intake or Short Ram Intake. Select Si or Non-Si based on your application. DOES NOT fit stock airbox.
• Pair with the PRL Race MAF Housing & Intake Systems for Optimal Performance

WHAT'S IN THE BOX?

• (1) Cast Aluminum Inlet Piece
• (1) 76mm OD Titanium Inlet Pipe
• (2) High-Temp 4-Ply Silicone Couplers
• (5) 304 Stainless Steel Interlocking Worm Clamps
• (4) Vacuum Hoses
• (1) Injection Molded Evap Purge Fitting
• (2) Buna O-Rings
• (1) Bolt
• (1) Wiring Harness Tie-Down