Nuke Performance Fuel Cell Vent Kit AN-8

Nuke Performance Fuel Cell Vent Kit – AN-8
Part No: 150-22-208

The AN-8 Fuel Cell Vent Kit from Nuke Performance is a complete, easy-to-install solution for safely venting your aftermarket fuel cell. Whether you're running a custom setup or a CFC Unit, this kit is built for performance and reliability in motorsport environments.

Key Features:

Complete vent kit with all required fittings
1m (3.3ft) nitrile AN-8 fuel hose included
Compact, universal air filter with AN-10 ORB thread
Compatible with petrol, ethanol, methanol, E85, E100, and diesel
Fits most aftermarket fuel cells (ATL, Pyrotect, Fuel Safe, Radium, etc.)

Kit Contents:

1x Universal air filter (AN-10 ORB thread)
1x AN-10 ORB to AN-8 male fitting
2x AN-8 Full Flow straight fittings
1x 1m AN-8 nitrile fuel hose

Installation Tips:

Always use a roll-over protected vent fitting
Route the hose upward for 20cm, then into loops to trap any fuel vapour
Vent line must exit higher than the filler and outside the cabin, away from heat

This AN-8 kit strikes the perfect balance between flow and compact routing, ideal for both street and race builds.